I am aware that he is in a completely empty cell and more than 20 meters from another poke stop, but today that should have appeared in the game and it just appears like this, why? I can do something?
Hello and Welcome,
How did you confirm this?
If you are happy to pass the long / lat co-ords we can check for you…
I just read in the same forum that it could be because it has not yet entered the sync, they approved the request today, just 3 hours before the time when the poke stops usually appear, can it really be because of that?
And these are the coords: 18.9034239, -99.2195534
It’s a little bit lower than the co-ords but definitely looks to be an empty cell.
Hang tight.
Good Luck…
1 Like
Thank you very much, I notice what happened tomorrow if anyone else has any doubts. 
It can take up to 48 hours for Wayspots to appear in Pokemon Go, if they are eligible.
Edit:
Please be sure to place the submission pin accurately, as your Wayspot was submitted 50 metres away from the correct location.
The real location appears to be 18.903877, -99.219468
Excuse me, where do you check that? I am also a reviewer for wayfarer, I am always aware of not sending duplicates and I usually follow the requirements, but nowhere could I see that this wayspot already existed, in the same way, at the time of the proposal I was very clear when I said that it was a complete walker stop, the plate was merely the image of it.
Hello, sorry, I made a partial mistake. 
It’s not a duplicate – the other one does not appear in the duplicates. That is my bad, I was experimenting with a tool and misread it.
I have edited my post to reflect the correct information.
Oh no, no problem, I just threw me off, I constantly review proposals around the area and I had never had the duplicate Haha.
1 Like